Dental Silicone Impression Material Putty Light Body Materials 50ml

Description: THE PRODUCT DESCRIPTION Product UseMainly used for conveying impression materials, suitable for oral models in stomatology clinic Product CharacteristicsSilicone rubber is suitable for oral models printed in stomatology.2. Silicone rubber impression has good dimensional stability and can be sent directly to the mechanic's office or filled with gypsum model many times without immediate injection, and the impression is not easily damaged.3. Accurate impression, good detail reproduction, perfect restoration effect, improve product quality, improve customer satisfaction, but also bring good experience to patients.Easy operation, convenient and easy to learn.5. Suitable for crown-bridge, inlay and high-inlay impression.6. Use in conjunction with type 0 silicone rubber.7. Two-step or one-step (double mixing) impression technology may be used. How to use1. Choosing the right pallet for the patient requires 3-4mm away from the patient's teeth because the thickness of the impression material at this distance is uniform, which avoids the problem of deformation due to uneven force on both sides.It is recommended to use stainless steel tray to take out molds that are not easy to deform. It is recommended to use light-cured individual tray materials of Shanghai pigeons to meet the needs of different patients. 2. Clean and dry hands in order to prevent poor solidification of polymeric silicone rubber, the following points should be noted:①Materials should be kept away from direct sunlight, and the recommended temperature should be less than 25 degrees Celsius, and normal indoor humidity should be maintained (stored in the refrigerator in summer).②Latex gloves should not be worn during operation, and foreign substances such as hand cosmetics or talc powder should not be touched, and thin film gloves are recommended.③The patient should gargle several times to prevent residual Chinese medicine or betel nut components from curing. 3. Take the first impression①Use different color spoon to measure the substrate and catalyst of the corresponding color. Top collar recommends 1 full spoon and bottom collar recommends 1 flat spoon to ensure a volume ratio of 1:1.②Use your fingertips to mix until the color is uniform and there are no stripes, indicating that the mixing is complete.The mixing time is 3053. The mixing time is 3053. The mixing time of silicone rubber is affected by the temperature, the temperature is high, the solidification speed is fast. 4. Fixing the initial impressionUse a special trimming knife to remove the recessed area between the primary impression shoulder table and the gum papilla tooth gap, trim the spillway, and extend it to the secondary impression position to reduce bubbles."The purpose of the trimming is to allow sufficient space for the secondary impression to reduce bubbles, reduce pressure on the high-precision impression, and assist the secondary impression in place." 5. Remove the front material 1-50pX immediately after the first removal of the cap; use the mixing head as a cap after use and remove it again after the next use to prevent contamination of the outlet. 6. Injection of secondary light body using secondary impression 7. Take the final impression①Place the tray filled with lightweight material slowly and in place at one time. After curing for about 3 minutes and 30 seconds, remove the tray from the mouth.②The impression made of type 3 silicone rubber has clear and complete undergum edges, no bubbles, clear and continuous shoulder platform, which makes it easy to make the restoration with close edges.③Polymerized silicone rubber impression can be taken out of the mouth and left for 30 minutes. It can be used for 30 days. It can be sterilized and sent directly to the technician's office. Package Note:If you order 4*50ml, you'll get free 6 mixing tips

Price: 16.62 USD

Location: tianjinshi

End Time: 2024-08-10T09:18:12.000Z

Shipping Cost: 0 USD