Diamond Solid Sharpening Steel Professional Knife Blade Sharpener Honing Rod

Description: Product DescriptionNote: Thoroughly clean the diamond surface with water after use, and use a nylon scrub brush to clean the surface after some times using. This will remove metal particles that stick on the diamond surface during the sharpening process. Always keep dry when store the diamond sharpener.About SHARPALSharpal Inc. is a leading manufacturer of professional and patented multifunction knife and tool sharpeners for the outdoor and sports, garden and workshop, and culinary and kitchen industries. For more than 24 years we have been passionately researching and developing quality products, which provide consumers with an easy and cost-effective way to obtain a sharp edge.SHARPAL Diamond Sharpening Steel-the fastest and most effective way to sharpen an edge!Use and CareThere is a ‘break-in’ period for diamond sharpeners. When first use, the surface will appear to be especially rough. This roughness is due to the final manufacturing process and will be removed over time without impacting performance. As the diamond surface wears down, more and more diamond grits are exposed and the sharpener cuts faster.Sharpen dry. No messy oil neededInitial break-inClean surface and wipe DRYStore DRYSharpen most of super hard steel that being used by knife manufacturers includingNon-Stainless SteelsD2, A2, W-2, 10-series (1095, 1084, 1070, 1060, 1050, etc.), O1, Carbon V, 50100-B (0170-6), 5160, CPM 10VStainless Steels420 (420J), 440A (and similar grades including 425M, 420HC, and 6A), 440C (and similar grades including Gin-1, ATS-55, 8A), 154CM (ATS-34), VG-10, S30V, S60V (CPM T440V) / S90V (CPM T420V), 12C27, AUS-6 / AUS-8 / AUS-10 (also 6A / 8A / 10A), ATS-34, BG-42, Damascus Steel.Key FeaturesExcellent quality controlEach diamond sharpeing rod undergoes multiple inspections before leaving the factory.Anti-slip Ergonomic HandleSlip-resistant plastic handleBuilt-in hole for hangingMonocrystalline diamondThe common market uses Polycrystalline Diamond, a fragmented compound, which shatters off a new face after each sharpening, thus it wears away rapidly.SHARPAL uses Monocrystalline Diamond, a single structure that does not break with use for exceptional durability and lifespan.Over-sized Safety Hand GuardThe hand guard measures 2.2 inches in width to protect hands from hurting by blades.How to Use1. Position the sharpening rod vertically point down on a cutting board, table or other suitable surface. (See Fig. 1) Apply sufficient downward pressure on the sharpening rod to avoid slip during the sharpening process.2. Angle between the knife blade and sharpening rod should be approximately 20 degrees. (See Fig. 2)3. Place heel of your knife blade at the top of the sharpening rod at approximately 20 degrees. With consistent downward pressure, push the knife downward along the rod while pulling the knife towards you from heel to tip of the knife blade. (See Fig. 3)4. Repeat this action on the opposite side of the knife blade. (See Fig. 4)5. Repeat Step 3 & 4 until knife is sharp. Always take alternating passes with your knife across the sharpening rod applying appropriate pressure.

Price: 25.99 USD

Location: Ontario, California

End Time: 2024-11-17T06:50:19.000Z

Shipping Cost: 0 USD